This patch enables a user to opt for HDCP per output, by writing into
the output section of weston.ini configuration file. HDCP is always
enabled by default for the outputs.
Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
The change in an output's content-protection may trigger a change in
the surface's content-protection status, and inturn the
content-protection available for the client.
This patch recomputes the content-protection level for a surface,
in case there is a change in content-protection level of an output,
showing the surface. In case of a change in the surface's
content-protection, the client associated with that surface is
notified.
Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
This patch adds the content-protection protocol implementation, to
enable a weston client application to request for content-protection
for its content via HDCP.
Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
The protection requested for a given surface, must reach through the
weston_surface::pending_state, in the commit-cycle for the
weston_surface, so that it gets updated in the next commit.
As some protection is requested for a given weston_surface, it means
protection must be set for each of the outputs which show the surface.
While setting the protection of a weston_output, care must be taken
so as to avoid, degrading the protection of another surfaces, enjoying
the protection. For this purpose, all the weston_surfaces that are
shown on a weston_output are checked for their desired protection.
The highest of all such desired protections must be set for the
weston_output to avoid degrading of existing protected surfaces.
A surface requesting protection for a lower content-type can still be
provided protection for a higher type but the converse cannot be
allowed.
This patch adds support to set content-protection for a suface, which
inturn sets the content-protection for each of the outputs on which
it is shown, provided, none of the existing surface's protection
request is downgraded.
Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
The actual protection status for a given weston_head depends upon the
corresponding drm_head's connector HDCP properties. On the other hand,
the actual protection for a weston_output is the minimum of the
protection status of its attached heads.
As a head's protection changes, the current protection of the output
to which the head is attached is recomputed.
This patch adds the support to keep track of the current
content-protection for heads and the outputs.
Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
For making an output secure, the content-protection should be set for
each of head attached to that output. So whenever the protection for
a weston_output is desired, it means that protection is desired for
each of the weston_head attached to that weston_output.
This patch introduces a new enum in libweston to represent the
requested/current protection statuses, equivalent to the type enum
defined by the weston-secure-output protocol. The new enum helps to
extend the content-protection status and requests to libweston and
the backends.
This patch also adds a new member desired_protection to store the
desired protection for an output in weston_output.
Signed-off-by: Ankit Nautiyal <ankit.k.nautiyal@intel.com>
The xdg-output resources are listed in each head struct. They become idle when
the respective weston_output has been removed again. The client is supposed to
destroy them explicitly afterwards.
After starting an XWayland client xrandr displays the logical size as expected.
Signed-off-by: Roman Gilg <subdiff@gmail.com>
Also, add tag symbols related to 'weston_head'.
The bridge between sphinx and doxygen (breathe) has a useful directive:
doxygengroup. By using it we can scoop out symbols we'd like to display
documentation from/of.
At the same time some bits of the code has been using '\memberof' (a
doxygen command useful in C code to establish class like
relationship between objects and functions) but this seems not to be
recognized by the sphinx bridge.
Until we find a better solution, we replace '\memberof' command with
'\ingroup' one as to tag the symbols with an "object". This patch does
that for 'weston_head' object.
Signed-off-by: Marius Vlad <marius.vlad@collabora.com>
With these aliases we can use rST directives inside comment blocks. This
adds also a doxygen command '\rststar' where ignores the asterisk --
typical to multi-line comment blocks.
While at it, add a simple example on how to use them.
Signed-off-by: Marius Vlad <marius.vlad@collabora.com>
By default the client communicates its preference with regards to
compression to the server. However, some clients always use
compression, which is not ideal for certain environments (e.g.
low performance embedded devices in a local network with plenty
of bandwidth). Allow to disable compression server-side which will
override the clients request for compression.
Signed-off-by: Stefan Agner <stefan@agner.ch>
When using logind launcher, we receive a PauseDevice "gone" message
from logind session management for each device we close while looking
for KMS devices.
Make logind notify the backend of the device add/remove so that the
backend can decide what to do, instead of assuming that if it is a
DRM_MAJOR device the session should be (de)activated. The backend can
then react to its specific device.
Fixes#251
Signed-off-by: Robert Beckett <bob.beckett@collabora.com>
As we transition towards a more generic API for weston loggging
framework rename weston_debug_compositor to weston_log_context to show
the fact that this is not really debug but a logging context.
Signed-off-by: Marius Vlad <marius.vlad@collabora.com>
This patch allows initialization of weston-debug/log framework much earlier
than weston_compositor, which in turn will provide the option start
logging before weston_compositor has been created.
Signed-off-by: Marius Vlad <marius.vlad@collabora.com>
Seems that these functions: weston_compositor_fade()/weston_compositor_unlock()
lost their implementation a while ago.
Signed-off-by: Marius Vlad <marius.vlad@collabora.com>
The documentation of wl_data_offer::finish states that it should be
used to signify that a drag and drop operation is completed. So send
WL_DATA_OFFER_ERROR_INVALID_FINISH when the client calls the finish
request but the operation isn't dnd.
Signed-off-by: Harish Krupo <harishkrupo@gmail.com>
This is an installed public header, and without the subdir would surely
conflict with something else.
include/libweston/meson.build is necessary for putting the generated header in
the right subdirectory so that '#include <libweston/version.h>' can work.
Signed-off-by: Pekka Paalanen <pekka.paalanen@collabora.com>
It is a public installed header used by libweston.h.
See "Rename compositor.h to libweston/libweston.h" for rationale.
Signed-off-by: Pekka Paalanen <pekka.paalanen@collabora.com>
It is a public installed header used by libweston.h.
See "Rename compositor.h to libweston/libweston.h" for rationale.
Signed-off-by: Pekka Paalanen <pekka.paalanen@collabora.com>
matrix.h is a public installed header and even used by libweston.h.
See "Rename compositor.h to libweston/libweston.h" for rationale.
Signed-off-by: Pekka Paalanen <pekka.paalanen@collabora.com>
The backend headers are renamed from compositor-foo.h to backend-foo.h to
better describe their purpose. These headers are public libweston API for each
specific backend.
The headers will also be used like
#include <libweston/backend-drm.h>
instead of
#include <compositor-drm.h>
to give them a more explicit namespace.
Signed-off-by: Pekka Paalanen <pekka.paalanen@collabora.com>
The main idea is to make libweston users use the form
#include <libweston/libweston.h>
instead of the plain
#include <compositor.h>
which is prone to name conflicts. This is reflected both in the installed
files, and the internal header search paths so that Weston would use the exact
same form as an external project using libweston would.
The public headers are moved under a new top-level directory include/ to make
them clearly stand out as special (public API).
Signed-off-by: Pekka Paalanen <pekka.paalanen@collabora.com>
This patch sets up the stage for similarly renaming compositor.h which will
justify this. That patch will be big, so moving timeline-object.h first makes
it easy to see the changes to the build and install directives.
This and all the following moves essentially break the API, so libweston major
is bumped.
Signed-off-by: Pekka Paalanen <pekka.paalanen@collabora.com>
Ankit Nautiyal
Roman Gilg
Marius Vlad
Stefan Agner
Robert Beckett
Harish Krupo
Pekka Paalanen